Steps
STEP 1
Press and hold the power button on the side of the tool, making sure to place the hand below the indicated line shown on the tool.
Tools

STEP 2
Continue to hold down the power button and the LED lights will flash to indicate that the tool is calibrated.
Tools

STEP 3
Continue to hold the power button and move the tool slowly across the surface. Once a stud is found, all the LED lights will illuminate.
Tools

STEP 4
Once the stud is found press the button to mark where the stud is.
Tools

TIP #1
If the LED lights calibrate, but no lights appear when it is moved, move the device and calibrate again.
Tools

Tip #2
If the LED lights flash repeatedly, move the device and calibrate the LED lights again.
Tools
